Cannondaleriders

Hi all,

I am assisting kdxboy and 02cannibal on the D&M project.
We have the USB code working now but I need a bench top setup so I can debug the USB code. After the debug its all gravy.

kdxboy is using an ECU with the fuel pump transistors blown up and something like that should work just fine for me as well.
Also, will need a wiring harness. Hopefully the ECU still has code loaded in it that will allow it to communicate?


I will pay ya for it and shipping.

If anyone has a either or both of these please contact me and we can figure out the gory details of payment and shipping.

Thanks,
Mike

Dave thanks.

Guys the software hardware for this project is real close to beta release. At this point I think what is needed is some live testing.

I have a cable and software at my place in Temecula for testing and development. I think the best approach would be to have a running machine, someone prefereably with a D&M, and that knows how to use it.

This would enable us to verify the software against the Optimum software and verify our results.

Anyone in so cal can contact me at 951-294-8967

mike