Page 1 of 3
Posted: Sun May 10, 2009 3:00 am
by mydreamride
heres my lastest master peice for my quest to a quiter pipe. Enjoy
Merge collector
Posted: Sun May 10, 2009 3:14 am
by mydreamride
header & muffler
Muffler is an oem muffler off a 2001 Yamaha R1 then shortened approx. 5".
The full exhaust weights roughly 8 lbs. Will take more photos when I get the pipe off so you can see the merge collector and the header flange better.
Posted: Sun May 10, 2009 3:18 am
by mydreamride
header & muffler with the stock gas tank
Posted: Sun May 10, 2009 3:31 am
by mydreamride
Heres what the inside of the muffler looks like. Notice the three seperate chambers , and the arrows I drew to show the path the exhaust goes thru. Nice and quite, can even talk on the phone while running it without distorting the phone even while standing next to it
Posted: Sun May 10, 2009 3:59 am
by thedeatons
Dyno tune it and let's see the difference!
Posted: Sun May 10, 2009 4:09 am
by mydreamride
Dyno tune it and let's see the difference!
Going to see if I can get in very shortly, found a dyno 40 minutes away and 5 minunts from work. Want compare it to the fmf, and my center mount I made a few months ago.
Posted: Sun May 10, 2009 5:17 am
by peterock
Looks very nice, especially the header. That canister is friggen huge though. Wow. Any clearance issues hitting the axle???
Posted: Sun May 10, 2009 9:51 am
by claas900
Man you do good work.
Posted: Sun May 10, 2009 12:27 pm
by mydreamride
Looks very nice, especially the header. That canister is friggen huge though. Wow. Any clearance issues hitting the axle???
axle clears, but the caliper may gently tap a very small spot (not worth worrying about). will take a pic to show the clearance
Posted: Sun May 10, 2009 12:49 pm
by speedracer
Nice work.You need to build an extra gas tank and sell it to me!