falicon crank

Message

cdale490 · #1 Post by **cdale490** » Thu Nov 12, 2009 3:08 am

Hay guys I bought a falicon stroker crank and it didnt have the drive gear for the counter balance shaft on it so I pressed the one off the stock crank and went to put it on the falicon crank and it slides on and off with your fingers not sloppy lose, but lose is this normal?

Happyboy · #2 Post by **Happyboy** » Thu Nov 12, 2009 3:23 am

Nope. It should press on.

peterock · #3 Post by **peterock** » Thu Nov 12, 2009 3:26 am

Hope you didn't pay too much for that crank. Probably would have been better having your stock crank stroked.

wistech · #4 Post by **wistech** » Fri Nov 13, 2009 11:43 am

It has to press on because it drives the countershaft . The pin will shear right away if not tight on the shaft. Send it back to falicon and have them replace it with a good crank half. If handled correctly they should do it for free.