Balljoint to Heim Joint Conversion

[cdsracer]

I????????ve been working on a replacement solution for weak balljoints on my Moto, 02 and 03 style A-arms. I came up with a heim joint conversion using Walsh Racecraft hardware. I am having the original cups on the 02, 03 and lower Moto A-arms milled out, then I am installing new weld-in cups and heim joints with Cannondale taper studs. I completed this conversion on five quads (two 02????????s, two 03????????s and a Moto) and have put 430 miles on them so far. They retain original geometry and structural integrity and allow for full suspension travel. Let me know what you think.

[2000ex]

Solid setup. For MX racing I like the spherical bearings as well.

The good part is once you have the studs and cups from Walsh, the replacement sphericals are cheap.

COM12-T bearings are about $15 each

[cannondale27]

Very nice! Between your conversion for lowers and boomers conversion for uppers along with the Poly bushings I believe Moto A-arms are set. Nice.

[joep1219]

i'm all over that! you going to be marketing these? i would def. be interested in a set up, even if it ment sending my arm out to ya or to a machine shop.

[cdsracer]

Yeah, I can put some together for you. Check your pm's.

[desertbound]

Same thing I did on the arms I built for the glamis I had. They work really well.

[Bvcracingcdale]

I need to do this conversion...very nice

Anyone have into on the a arm bushings also?

I already converted my uppers

[Canniboomer]

I have a complete Bushings Kit now for the Moto A-Arms -- Urethane Black stepped bushings, metal T-sleeves, spec grease, misc -- $105.
email or call if interest, tks.