Page 4 of 4
Posted: Fri Jan 01, 2010 2:29 am
by cannondale27
Just hose everything down with the soapy water. Any leaks will show and it doesn't hurt a thing.
Posted: Fri Jan 01, 2010 3:33 am
by Z4J
Will do. Thank you 27.
Posted: Fri Jan 01, 2010 3:06 pm
by Z4J
You're adding the air at the plug opening just as you would a leak down correct? Photos missing..
Posted: Fri Jan 01, 2010 3:32 pm
by cannondale27
No. But you could. Otherwise leave plug in. It doesn't matter since the air will pressurize the case just about anywhere you hook it up. You just have to temporarily seal off all the normal oil/vent flow points. Just use the engine hoses that go to frame on the motor and use thier free ends to block off any open holes. I usually put the air to the oil inlet at back of motor because that is one hose I leave on frame when engine is removed. Kdeal has a engine plug kit that also works nice for this. It's just all the plastic plugs to seal off the motor so no dirt or insects get in there before install.
Posted: Fri Jan 01, 2010 4:07 pm
by Z4J
Great. Thank you Steve.
Posted: Fri Jan 01, 2010 5:45 pm
by cannondale27
No problem. Don't forget 5-10psi max.
Posted: Sat Jan 02, 2010 7:06 am
by claas900
I also made a video of this if that helps any.
Posted: Sat Jan 02, 2010 1:49 pm
by Z4J
It wouldn't hurt at all. Is there a link for it? Thanks.
Posted: Sat Jan 02, 2010 1:58 pm
by claas900
It wouldn't hurt at all. Is there a link for it? Thanks.
Yeah Its a few post up.
Posted: Sat Jan 02, 2010 5:21 pm
by Z4J
Missed it. Have it now. Excellent. Thank you.