Page 1 of 1
Wiring harness upgrade!
Posted: Thu Dec 08, 2005 2:20 pm
by haydug
$$$$ shipped back to you.
Here is a picture of my harness, basically it is gutted, all extra grounds removed, and moved up to mount on rectifier. 3 relay setup (factory, fan, fuel pump) along with in line fuses. This is a top notch job. You can either keep or remove the headlight/tailight wires.
Paypal to:
haydugel@zoomnet.netI will pm you with the address to ship the harness to. Your harness must be in working order, and CLEAN when shipped.
Posted: Thu Dec 08, 2005 2:21 pm
by haydug
pic.
Posted: Thu Dec 08, 2005 2:38 pm
by Craig_C
May be a dumb question or two...
Will it work with a fuel pump re-located?
Is it smaller and easier to work with than the stock wiring har-mess?
Posted: Thu Dec 08, 2005 7:18 pm
by haydug
QUOTE
Originally posted by Craig_C
May be a dumb question or two...
Will it work with a fuel pump re-located? Yes, actually if you move it to the rear, he can lengthen your factory wires, and re-seal them, to wheatever length you wish.
Is it smaller and easier to work with than the stock wiring har-mess?
smaller and easier yes. .
Posted: Thu Dec 08, 2005 7:26 pm
by Craig_C
Good deal! :head:
Posted: Thu Dec 08, 2005 7:50 pm
by haydug
Maybe you can get an idea with this picture.
Posted: Thu Dec 15, 2005 8:18 pm
by Happyboy
what is that big honkin aluminum block looking thing in front of the stem?
Posted: Thu Dec 15, 2005 8:59 pm
by haydug
QUOTE
Originally posted by Happyboy
what is that big honkin aluminum block looking thing in front of the stem?
That is actually a fuel pump mount
Posted: Fri Dec 16, 2005 1:42 am
by hnnblehscnnble
i thought it was a fuel rail:confused: but that sounds like a good idea odesnt it.make one outta an aluminum block with fins machined into it mounte dunder ecu tray for cooling.run hose after left injector up to fuel rail,then from fuel rail to before right injector.hmmm:p
kyle