Wiring harness upgrade!

Post Reply
Message
Author
haydug
Posts: 0
Joined: Wed Mar 10, 2021 10:41 pm

Wiring harness upgrade!

#1 Post by haydug »

$$$$ shipped back to you.

Here is a picture of my harness, basically it is gutted, all extra grounds removed, and moved up to mount on rectifier. 3 relay setup (factory, fan, fuel pump) along with in line fuses. This is a top notch job. You can either keep or remove the headlight/tailight wires.

Paypal to: haydugel@zoomnet.net

I will pm you with the address to ship the harness to. Your harness must be in working order, and CLEAN when shipped.

haydug
Posts: 0
Joined: Wed Mar 10, 2021 10:41 pm

#2 Post by haydug »

pic.

Craig_C
Posts: 0
Joined: Wed Mar 10, 2021 10:41 pm

#3 Post by Craig_C »

May be a dumb question or two...

Will it work with a fuel pump re-located?

Is it smaller and easier to work with than the stock wiring har-mess?

haydug
Posts: 0
Joined: Wed Mar 10, 2021 10:41 pm

#4 Post by haydug »

QUOTE
Originally posted by Craig_C
May be a dumb question or two...

Will it work with a fuel pump re-located?    Yes, actually if you move it to the rear, he can lengthen your factory wires, and re-seal them, to wheatever length you wish.

Is it smaller and easier to work with than the stock wiring har-mess?
smaller and easier yes. .

Craig_C
Posts: 0
Joined: Wed Mar 10, 2021 10:41 pm

#5 Post by Craig_C »

Good deal! :head:

haydug
Posts: 0
Joined: Wed Mar 10, 2021 10:41 pm

#6 Post by haydug »

Maybe you can get an idea with this picture.

Happyboy
Posts: 0
Joined: Wed Mar 10, 2021 10:41 pm

#7 Post by Happyboy »

what is that big honkin aluminum block looking thing in front of the stem?

haydug
Posts: 0
Joined: Wed Mar 10, 2021 10:41 pm

#8 Post by haydug »

QUOTE
Originally posted by Happyboy
what is that big honkin aluminum block looking thing in front of the stem?



That is actually a fuel pump mount

hnnblehscnnble
Posts: 0
Joined: Wed Mar 10, 2021 10:41 pm

#9 Post by hnnblehscnnble »

i thought it was a fuel rail:confused: but that sounds like a good idea odesnt it.make one outta an aluminum block with fins machined into it mounte dunder ecu tray for cooling.run hose after left injector up to fuel rail,then from fuel rail to before right injector.hmmm:p

kyle

Post Reply