Page 1 of 5
$10 gift cert. from "canniboomer"
Posted: Sun Dec 04, 2005 10:28 pm
by haydug
The first guess to get this correct, will receive $10 off of their next order from Dave ("canniboomer"). I would say this is a fine time to place your order for his awesome intake kit:
I just had these 2 "tools" machined. What are they used for?
Posted: Sun Dec 04, 2005 10:39 pm
by haydug
These are open on 1 end, and closed on the other. They are made from Brass.
Posted: Sun Dec 04, 2005 10:51 pm
by azcannon
knocking out bearings
Posted: Sun Dec 04, 2005 10:55 pm
by CptHook
yarghhhh! New cannons for me ship?!
Posted: Sun Dec 04, 2005 11:01 pm
by jesshamner
If those are cannons, they're pretty small.
Posted: Sun Dec 04, 2005 11:34 pm
by omegas
making holes in cases for a kick start
Posted: Sun Dec 04, 2005 11:59 pm
by Speed 1B
Some kind of bearing drivers...
Posted: Mon Dec 05, 2005 12:58 am
by haydug
QUOTE
Originally posted by azcannon
knocking out bearings
Getting warm
Posted: Mon Dec 05, 2005 12:59 am
by haydug
QUOTE
Originally posted by Speed 1B
Some kind of bearing drivers...
Getting warmer!
You must be specific on these. It is something I will use regularly with each engine rebuild.
Posted: Mon Dec 05, 2005 1:05 am
by Stunz
It's hollow (ID) to slide over a shaft.
The outside diameter is to retain bearings.
It must be for the crank or tranny. But since I've never "dug" in that deep so I can't be specific.