$10 gift cert. from "canniboomer"

Message

haydug · #1 Post by **haydug** » Sun Dec 04, 2005 10:28 pm

The first guess to get this correct, will receive $10 off of their next order from Dave ("canniboomer"). I would say this is a fine time to place your order for his awesome intake kit:

I just had these 2 "tools" machined. What are they used for?

haydug · #2 Post by **haydug** » Sun Dec 04, 2005 10:39 pm

These are open on 1 end, and closed on the other. They are made from Brass.

azcannon · #3 Post by **azcannon** » Sun Dec 04, 2005 10:51 pm

knocking out bearings

CptHook · #4 Post by **CptHook** » Sun Dec 04, 2005 10:55 pm

yarghhhh! New cannons for me ship?!

jesshamner · #5 Post by **jesshamner** » Sun Dec 04, 2005 11:01 pm

If those are cannons, they're pretty small.

omegas · #6 Post by **omegas** » Sun Dec 04, 2005 11:34 pm

making holes in cases for a kick start

Speed 1B · #7 Post by **Speed 1B** » Sun Dec 04, 2005 11:59 pm

Some kind of bearing drivers...

haydug · #8 Post by **haydug** » Mon Dec 05, 2005 12:58 am

QUOTE

Originally posted by azcannon
knocking out bearings

Getting warm

haydug · #9 Post by **haydug** » Mon Dec 05, 2005 12:59 am

QUOTE

Originally posted by Speed 1B
Some kind of bearing drivers...

Getting warmer!

You must be specific on these. It is something I will use regularly with each engine rebuild.

Stunz · #10 Post by **Stunz** » Mon Dec 05, 2005 1:05 am

It's hollow (ID) to slide over a shaft.
The outside diameter is to retain bearings.

It must be for the crank or tranny. But since I've never "dug" in that deep so I can't be specific.