Handel Bar Mounting Plate
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
Handel Bar Mounting Plate
I have a Cannibal and I wanna put renthal bars on it. However I wanted to get a plate for the keyswitch and tether switch. I saw one custom made on ebay that even had an hour meter and the Diagnostic display lights on it. However it's not on ebay anymore and I can't find anything anyware. Any suggestions??
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
OK, these will give you an idea: 2x35 watt trailtechs downmounted from 1/4" billet plate, only mounted to the two forward clamp bolts -- that center boot is to plug in a single helmet HID light 13w... even without the helmet light, just these 2 basic halogens at 70w are a HUGE (2x) improvement over the stockers pulling 75w..
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
this view shows the Tach/Hourmeter and locations for all three status lights and a kill switch...all is viewable while riding with either version of the steering stem -- this quad has the older vertical offset stem. I'm not selling the status lights, but any of the kits could be used with this mounting. Email or call for options,versions, pricing -- different for fatbars vs. 7/8"...
Also note, same light yoke can be used underneath bottom clamps with topmounted lights, or together with Speed2424 frontplate, lots of combinations, no 2 quads exact same.
Also note, same light yoke can be used underneath bottom clamps with topmounted lights, or together with Speed2424 frontplate, lots of combinations, no 2 quads exact same.