Tires and wheels

[justfine]

Jeff or Marty might be best to answer this, but may be somebody else will know. I would like to start running the new holeshot mxr on the rear of my Moto. I would also like to put them on Hiper wheels. Here is my question: What Hiper wheels and what offset should I get. I would like to widen the rear of my Moto to a full 50". Any help would be appriceated. Thank you......

[DirtDragon]

Cannondale offset will widen the rear by 3" and 1.5" in the front

[justfine]

I looked on the Hiper website, and it showed them making many different offsets for cannondale. Could someone explain this in depth?

[Knight440]

Honda front's are 4-1's the Dale's are 3-2's

[JeffQuadShop]

I'm pretty sure that the stock Cannondale offset (4+6) is the most offset that you can get from Hiper. So it won't make it any wider (they didn't on my Blaze). The front is the same deal, Cannondale offset is 3+2. Stock Honda is 3.5+1.5.

Hope this helps!

[justfine]

Jeff, what could I do to widen the rear end a little bit? Tried to go the spacer route, did not work like I wanted.....

[JeffQuadShop]

The only way to do it correctly is to get an aftermarket axle.

[justfine]

what company would make one that would do the job I am looking for?

[JeffQuadShop]

Either LSR or RPM.

[drbowtie]

I am a proud owner of new hi per tech carbon fiber wheels. Just bought them an hour ago from hi per tech. The factory rims are set off 3 inches on the inside and six on the outside. The rims are nine by nine and I got the yellow ones to match my speed! They were 192.00 beans... So, if you give me three shipping days I'll give ya the low down on em!