ball joints for herman a-arms

Message

tomi440 · #1 Post by **tomi440** » Wed Nov 18, 2009 10:38 pm

Hey guys,
I bought my quad with Herman +3s on it. I need to replace my balljoints so I went ahead and bought joints for a dale. but they are definitly too small.

could anyone point me in the right direction?

thanks

2000ex · #2 Post by **2000ex** » Wed Nov 18, 2009 10:46 pm

Pretty sure all Hermann arms use spherical bearings and kingping. Also fairly certain the bearing you are looking for is a COM12T...the t being for TEFLON lined. Same spherical bearings as in the Walsh arms. You can source them at most any local bearing shop.

moto440 · #3 Post by **moto440** » Thu Nov 19, 2009 3:27 pm

also you could call herrmann and ask them

tomi440 · #4 Post by **tomi440** » Fri Nov 20, 2009 12:30 am

thanks guys, ill check the bearing shop!