A-arms

Message

KYmxracer52 · #1 Post by **KYmxracer52** » Mon Oct 06, 2003 6:37 pm

Does anyone know if Arens have their new arms made for Cannondale yet?

KYmxracer52 · #2 Post by **KYmxracer52** » Wed Oct 08, 2003 2:40 am

Is anyone running Lonestar A-arms on their dales? I'm trying to decide which brand to buy. Im wanting standard travel. I just wanted to hear some feedback on what everyone has experienced with them. Good or bad.

Derno24 · #3 Post by **Derno24** » Wed Oct 08, 2003 3:30 am

What size arms were you looking for in stanrdard travel??? I have made some calls and could tell you what I know about +1 arms.

KYmxracer52 · #4 Post by **KYmxracer52** » Wed Oct 08, 2003 2:04 pm

i'm wanting +2 or +3 in standard travel. Does anyone know what width +3 arms would give with ZPS shocks? I want 50", but no more (with me on the quad). Is anyone running Dura Blue axles? What width do you have. I have around 48". Does Lonestar or RPM give 50"? Has anyone had any problems with those brands?

thomez · #5 Post by **thomez** » Wed Oct 08, 2003 2:54 pm

I think that +3 arms and 4/1 offset fronts give you the 50" you are looking for. That's what I'll be putting together.

I have a DuraBlue axle that I haven't seen yet. It is the Eliminator 2+2 deal so I should be able to have 48" or 50" with it, depending on if I use the spacers or not. At least that was the intentions when I got it. As far as I know that is the only DuraBlue they make for a Cannondale.

KYmxracer52 · #6 Post by **KYmxracer52** » Wed Oct 08, 2003 3:28 pm

I have the Eliminator in mine now, and I only have 48". I want a setup that gives me 50".

thomez · #7 Post by **thomez** » Wed Oct 08, 2003 3:38 pm

Do you have the spacers in there? I was fairly confident that it would get you to 50" - then again, I've been wrong b4.

KYmxracer52 · #8 Post by **KYmxracer52** » Wed Oct 08, 2003 4:35 pm

Yeah, im using the spacers that came with it.

haydug · #9 Post by **haydug** » Wed Oct 08, 2003 5:04 pm

Try using some 400ex rear hubs, they should work. I know they work on Lonestar axles, but not sure about you durablue. They will give you your extra width

Big Winky · #10 Post by **Big Winky** » Sun Oct 12, 2003 12:44 pm

Did you check out our a-arms?. they are built to "moto" specs, and we also build them in +1,2 for the standard length shocks.
www.diamondracingatv.com