BIG PROBLEM!! with lower a-arm ball joint
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
Very cool Wistech!
Now that's a solution. or will be anyway.
You convert arms and PC em, i'll send money! Take trade ins?
You convert arms and PC em, i'll send money! Take trade ins?
http://www.cannondaleriders.com/vbb/showth...42090#post42090 here it is....hope it helps .if you run LSR arm on the front, DONT buy replacment parts from them. heres a little info i found surprising.
Upeer A-arm rod end LSR retail 23 bux!
Summit racing retail 5.95!!
1/2 inch right hand thread (male)
tie rod ends LSR retail 26 bux!
Summmit racing retail 7.95!
1/2 inch right hand, left hand thread (female)
ball joints LSR retail 26 bux!
Parts store 14.95
GM truck tie rod end!! he he he
i build drag cars, and figure if these rods ends are good enough for the 4 link on cars, they'll do JUST FINE on a 400 pound quad!!
Upeer A-arm rod end LSR retail 23 bux!
Summit racing retail 5.95!!
1/2 inch right hand thread (male)
tie rod ends LSR retail 26 bux!
Summmit racing retail 7.95!
1/2 inch right hand, left hand thread (female)
ball joints LSR retail 26 bux!
Parts store 14.95
GM truck tie rod end!! he he he
i build drag cars, and figure if these rods ends are good enough for the 4 link on cars, they'll do JUST FINE on a 400 pound quad!!
http://forums.cannondaler.com/viewtopic.ph...er=asc&start=15
none of my arms look like this mine look more of a v no ??pipe
none of my arms look like this mine look more of a v no ??pipe
Oh yes the later arms were a simpler design. The ones in my picks are the older speed and cannibal arms. They are physically the same dimension and could be interchanged. I have 2 or three sets laying around here if you need them and Im sure many others have some they would donate to the project . My moto has the v type arms on it so I guess that will be another project for me :hammer:
wistech, could you please help these guys out
http://forums.cannondaler.com/viewtopic.php?t=4476
I could try but I'm sure you could give better information. They will appreciate it. Thanks
http://forums.cannondaler.com/viewtopic.php?t=4476
I could try but I'm sure you could give better information. They will appreciate it. Thanks
Been kind of busy lately . So have any of you guys got a book of specs on ball joints and tie rod ends. I keep hearing about using tie rod ends but they would have to be coated as most come as bare metal. I am also hesitant to use a tie rods end off a car because I am not sure they are rated for end loads. Any numbers off the aftermarket a arm parts would be nice to.