Spindle removal

Message

cdalemx301 · #1 Post by **cdalemx301** » Sat Oct 23, 2004 5:43 pm

Hey alright so i tried everythin but that pickle fork thing....The only way that has worked was to TORCH IT :head: but it only worked on gettin one side of the spindle out off the ball joint...i got the upper but the lower is like recessed more so its hard to get to with a hammer someone out there got netips???

Happyboy · #2 Post by **Happyboy** » Thu Oct 28, 2004 4:25 pm

Hammer on the side of the spindle, not the ball joint or the arm. Should pop right out. You can also get a tool to pull it out. I think Jay posted something.