sprocket hub
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
sprocket hub
I have a RPM axle and sprocket hub. The sprocket hub has become very loose and it's got to be replaced. I already have a new hub but my question is does the hub have to be pressed off and on with press or can I do it my self. Never had to do one of these but the new hub has a snap ring in it already so the old one must be held in with a ring also. Thanx
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
QUOTE
Originally posted by Blazinmoto
Derno, are you talking of the sprocket hub or the brake hub? With the locktite part confusing me, where do you put it?
311racer, what kind of press?
Derno, are you talking of the sprocket hub or the brake hub? With the locktite part confusing me, where do you put it?
311racer, what kind of press?
I am talking about the sprocket hub. Farrar would be the one to PM about this as he has done it. He posted before to basically use it to fill the gap in the splines.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
QUOTE
Originally posted by cannondale27
I used green Loctite but that didnt last long.Gave up on Lonestar axle and switched to moto one from Brad Oakley.
I used green Loctite but that didnt last long.Gave up on Lonestar axle and switched to moto one from Brad Oakley.
It isn't just green. It was a specific formula. I mean heck there is about 100 different types of loctite. I picked up the loctite book and man I got lost quick. I wish I could remember the number. esides this is for an RPM axle.