I got a set of used onesThey seem to have aton of side to side play in them.Should their be some spacers? they have on roller and one sealed bearing in them?
When you tighten them down.The nut goes past the cotter pin hole.There has the be a spacer between nut Or like hardkor said a tapered nuts.theres no way you coud run them the way they are.The bind the rotor and pads when turning You could put pin in but they would just lossen if you did it finger tight and hit the cotter then
I guess i have to buy the nuts.It going to cost me just as much for these used ones.As i should have bought new.Hardkor is going to make a short run of hubs.there $40 out of my pocket for two nuts
I tryed them with washers.Still got side to side play on my speed and the walsh.So i no its not the spindles.I'm not going to ruin my waves and pads over some play