Page 1 of 1
Posted: Tue Apr 04, 2006 3:16 am
by rubicon20032003
I got a set of used onesThey seem to have aton of side to side play in them.Should their be some spacers? they have on roller and one sealed bearing in them?
Posted: Wed Apr 05, 2006 3:15 am
by rubicon20032003
When you tighten them down.The nut goes past the cotter pin hole.There has the be a spacer between nut Or like hardkor said a tapered nuts.theres no way you coud run them the way they are.The bind the rotor and pads when turning You could put pin in but they would just lossen if you did it finger tight and hit the cotter then
Posted: Wed Apr 05, 2006 3:27 pm
by rubicon20032003
What kinda of washer? How thick? You should have sent them?
Posted: Thu Apr 06, 2006 1:00 pm
by Derno24
You must have ditched or lost their special nut and used the washer from the stockers by accident. Hardkor sent all the hubs with that weird nut.
Posted: Tue Apr 11, 2006 12:49 am
by rubicon20032003
I guess i have to buy the nuts.It going to cost me just as much for these used ones.As i should have bought new.Hardkor is going to make a short run of hubs.there $40 out of my pocket for two nuts
Posted: Tue Apr 11, 2006 12:58 am
by MyCannibal
$40.00 for two nuts.....WOW!!!....mine are worth more than that though......
dude just use washers like ****** did......i'm sure he didnt have a problem....
Posted: Tue Apr 11, 2006 1:00 am
by rubicon20032003
$16.25 each plus shipping. Sorry I don't rig my stuff up.the washers don't place right preload on roller bearing right ether.
Posted: Tue Apr 11, 2006 1:12 am
by rubicon20032003
I tryed them with washers.Still got side to side play on my speed and the walsh.So i no its not the spindles.I'm not going to ruin my waves and pads over some play
Posted: Tue Apr 11, 2006 1:43 am
by rubicon20032003
If washers work so good.Find me the right size and send them up.You have my address from paypal