Front hub bearing and seal numbers

Message

WJR · #1 Post by **WJR** » Sat Sep 02, 2006 12:45 am

Anyone got the numbers/sizes of the front hub bearings and seals...I want to get a set before I tear them apart. Searched and only found that they are thew same as 400ex, but no sizes.

Thanks,
WJR

cannondale27 · #2 Post by **cannondale27** » Sat Sep 02, 2006 4:21 am

Here you go.These are from a Moose kit #A25-1035
Bearing #6004RD
Bearing#6202RS
Seal#3503
Seal#4210

WJR · #3 Post by **WJR** » Sat Sep 02, 2006 5:50 am

Thank you C27:)
WJR

DMAC10 · #4 Post by **DMAC10** » Mon Jun 25, 2007 5:29 pm

QUOTE (WJR @ Sep 2 2006, 12:50 AM) <{POST_SNAPBACK}>

Thank you C27:)
WJR

What year 400ex??

Does Canniboomer or Black widow carry the kits.

I'm checking the dale out, and I'm sure these will need to be changed.

jesshamner · #5 Post by **jesshamner** » Mon Jun 25, 2007 6:24 pm

Yeah I'm thinking about getting new bearings for mine too. Do the seals from the moose kit work for the Cannondale? Or is it like the rear bearing kits for a 400ex and the seals don't work?

DMAC, where ya been lately?

DMAC10 · #6 Post by **DMAC10** » Mon Jun 25, 2007 8:21 pm

QUOTE (jesshamner @ Jun 25 2007, 01:24 PM) <{POST_SNAPBACK}>

Yeah I'm thinking about getting new bearings for mine too. Do the seals from the moose kit work for the Cannondale? Or is it like the rear bearing kits for a 400ex and the seals don't work?
DMAC, where ya been lately?

Hey Jess

I have been extremely busy with work, alot of road trips. The Dale has been started twice since before christmas. Once just to hear it run and yesterday to check the front end out. I had the a-arms powder coated and replaced all the tie rod ends and the arm connections. Thats when I noticed the hubs had a little play, nothing major just me being picky. I was wanting to hit the group ride but there was no way with my schedule. I'm hoping this fall that things work out. But its way to early to tell.

Actually changed the plastic to use the Quad tech hood, just playing around with different looks.( as usual ).

I seen that new boat of yours, Nice job on landing that thing. I bet it cleans up easier than the dale.

cannondale27 · #7 Post by **cannondale27** » Mon Jun 25, 2007 8:41 pm

Those are the actual #'s on the seals and bearings.They are not a 400ex kit from Moose.Its a Cannondale kit.We can still get some things normally

Canniboomer · #8 Post by **Canniboomer** » Mon Jun 25, 2007 8:44 pm

The OEM Cannondale inner seals are unique, with the flanged cup
[attachment=4006:Koyo_ATV...ngeseals.jpg]

Here is the best kit you will find, $39, with premium made-in Japan bearings and the orginal seals[attachment=4007:Koyo_ATV...frontkit.jpg]

I still have some post-recall made-USA Cannondale bearings, same price as the Koyo's set until gone.