Page 1 of 1
Tires and wheels
Posted: Tue Apr 29, 2003 9:30 pm
by justfine
Jeff or Marty might be best to answer this, but may be somebody else will know. I would like to start running the new holeshot mxr on the rear of my Moto. I would also like to put them on Hiper wheels. Here is my question: What Hiper wheels and what offset should I get. I would like to widen the rear of my Moto to a full 50". Any help would be appriceated. Thank you......
Posted: Wed Apr 30, 2003 7:42 am
by DirtDragon
Cannondale offset will widen the rear by 3" and 1.5" in the front
???????????
Posted: Thu May 01, 2003 6:14 pm
by justfine
I looked on the Hiper website, and it showed them making many different offsets for cannondale. Could someone explain this in depth?
Posted: Sat May 03, 2003 7:19 am
by Knight440
Honda front's are 4-1's the Dale's are 3-2's
Posted: Sat May 03, 2003 12:20 pm
by JeffQuadShop
I'm pretty sure that the stock Cannondale offset (4+6) is the most offset that you can get from Hiper. So it won't make it any wider (they didn't on my Blaze). The front is the same deal, Cannondale offset is 3+2. Stock Honda is 3.5+1.5.
Hope this helps!
ok....hmmmmmm
Posted: Sat May 03, 2003 1:45 pm
by justfine
Jeff, what could I do to widen the rear end a little bit? Tried to go the spacer route, did not work like I wanted.....
Posted: Sat May 03, 2003 2:02 pm
by JeffQuadShop
The only way to do it correctly is to get an aftermarket axle.
Posted: Sat May 03, 2003 2:09 pm
by justfine
what company would make one that would do the job I am looking for?
Posted: Sat May 03, 2003 2:15 pm
by JeffQuadShop
Either LSR or RPM.
Posted: Thu May 08, 2003 6:54 pm
by drbowtie
I am a proud owner of new hi per tech carbon fiber wheels. Just bought them an hour ago from hi per tech. The factory rims are set off 3 inches on the inside and six on the outside. The rims are nine by nine and I got the yellow ones to match my speed! They were 192.00 beans... So, if you give me three shipping days I'll give ya the low down on em!