400 parts on C-dale

Message

wyndzer · #1 Post by **wyndzer** » Mon Nov 04, 2002 12:27 am

The front shocks will fit, but the a-arms have a different angle on the ball joint.

JeffQuadShop · #2 Post by **JeffQuadShop** » Mon Nov 04, 2002 2:42 pm

The upper shock mount on the dale is wider than the 400's.

JeffQuadShop · #3 Post by **JeffQuadShop** » Mon Nov 25, 2002 2:35 am

Nope!

NRath · #4 Post by **NRath** » Mon Nov 25, 2002 6:20 pm

How about the rod ends? Will they bolt right up?

JeffQuadShop · #5 Post by **JeffQuadShop** » Mon Nov 25, 2002 7:48 pm

I don't believe so, Honda uses tapered ends.

NRath · #6 Post by **NRath** » Tue Nov 26, 2002 1:10 am

Alaska400EX- Didn't you get some Honda rod ends from Ricky Stator a while back??

Jeff- Have you seen any other rod ends for the dale?

JeffQuadShop · #7 Post by **JeffQuadShop** » Tue Nov 26, 2002 3:38 pm

QUOTE

Originally posted by NRath
Alaska400EX- Didn't you get some Honda rod ends from Ricky Stator a while back??

Jeff- Have you seen any [b]other rod ends for the dale? [/B]

Nope, haven't really looked. The stockers are great with the boots!

wyndzer · #8 Post by **wyndzer** » Tue Nov 26, 2002 3:59 pm

I use 400ex rod ends and tie rods, but I also have a Houser stem.

NRath · #9 Post by **NRath** » Tue Nov 26, 2002 5:53 pm

Did you taper drill the spindles?

wyndzer · #10 Post by **wyndzer** » Tue Nov 26, 2002 6:01 pm

the 400 tie rod ends fit right in, no mods required to the spindles.