Janssen Heims

Message

UpsMan · #1 Post by **UpsMan** » Sun Mar 25, 2007 10:09 pm

Janssen encapsulated heim joint. How hard would it be to get the pin with the cannondale taper? This one is for a honda.

cannondale27 · #2 Post by **cannondale27** » Sun Mar 25, 2007 10:30 pm

Wow that is slick!I worry a bit about two holes drilled in to keep cover on though.He also has some of the style Honda uses but rebuildable.Like said we need to get pins made or just use adapters.

wistech · #3 Post by **wistech** » Sun Mar 25, 2007 11:57 pm

If thats an 3/4" hiem the asr dale adapters should work fine. They may need a flat bolt head instead of the allen one though.

cannondale27 · #4 Post by **cannondale27** » Mon Mar 26, 2007 12:06 am

Does ASR use adapters or is the pin taper correct?

wistech · #5 Post by **wistech** » Mon Mar 26, 2007 12:24 am

They do not need adapters. They are built to fit in the spindle.