Page 1 of 1
Posted: Sun Mar 25, 2007 10:09 pm
by UpsMan
Janssen encapsulated heim joint. How hard would it be to get the pin with the cannondale taper? This one is for a honda.
Posted: Sun Mar 25, 2007 10:30 pm
by cannondale27
Wow that is slick!I worry a bit about two holes drilled in to keep cover on though.He also has some of the style Honda uses but rebuildable.Like said we need to get pins made or just use adapters.
Posted: Sun Mar 25, 2007 11:57 pm
by wistech
If thats an 3/4" hiem the asr dale adapters should work fine. They may need a flat bolt head instead of the allen one though.
Posted: Mon Mar 26, 2007 12:06 am
by cannondale27
Does ASR use adapters or is the pin taper correct?
Posted: Mon Mar 26, 2007 12:24 am
by wistech
They do not need adapters. They are built to fit in the spindle.