Cannondaleriders

I found a set of houser a arms and tie rods for a 250r will this setup work on my cannibal.
also they use 19in shocks.
What other types of a arms will work thanks.

I forgot to say that They are long-travel and take a 19" shock. They are +1 (further forward) and +3 over stock on the width.

Some say that this works if you use Honda spindles. I don't know, I haven't tried it yet. There is ton of info on this site if you use the search feature.

if i got the a arms would i have to use honda spindles or would the cannondale spindles and ect. work?
also would 250r long travel shocks work with them too if they were the right length?

If the a-arms are adjustable the Cannondale spindles will work with the cone adapters Canniboomer has. You need the adjustment to get the caster and camber correct. If not adjustable you will need the whole setup.

27 is right. The 250r set up is probably the closest you're going to get from another quad but the caster angle is slightly off if you're using the cdale spindle. So you'll need adjustable arms to adjust the camber angle back to stock. Or you could just find some 250r spindles and you'll be good to go.

I think +1 forward is the same geometry. I forgot to mention that in the recent thread about this set up.

so could i use the 250r shock that goes with them as well?
thanks

will i need new brake lines since the a arms will be plus 3.
becuase i found some for a 250r so would those work?
thanks

Yes you will need longer brake lines. I know for sure that galfer brake lines will work but I think brake lines are pretty much a univeral fit item.

if i got the 250r spindles woould the mount to the cannondale hub and rotars?