Page 1 of 1
400EX Rear Wheel Hubs?
Posted: Tue Jul 01, 2003 9:16 pm
by Dale512
I've heard that Stock 400EX Rear Wheel Hubs fit on the C-dales and make it wider. Is this true?
Thanks
?
Posted: Wed Jul 02, 2003 9:27 pm
by Dale512
Anybody?
Posted: Thu Jul 03, 2003 9:58 am
by JST
how much wider???
Posted: Mon Jul 07, 2003 12:16 pm
by Dale512
How much Wider?
Posted: Wed Jul 09, 2003 12:19 pm
by cannibal-87
i've heard 2.5" wider
Enquiring minds wanna know........
Posted: Thu Jul 31, 2003 1:33 am
by justfine
Ya, I would be really interested in the specifics on this. anyone?
If It will widen rear by a couple of inches I would love to pick up a set.
hmmmmmmmmm.............
Posted: Thu Jul 31, 2003 11:46 am
by justfine
Is it a really good fit?
Posted: Fri Aug 01, 2003 5:06 pm
by Brad77
Why would the 400ex hubs only fit on a stock axle? I think the splines are the same on the factory and aftermarket axles.
Posted: Fri Aug 01, 2003 7:05 pm
by Psychosis
I'm not sure on much about it but I've got a set of EX rear hubs ready to go on when I get mine back from the shop. I bought them not too long ago b/c somebody told me about 2.5 incheas which was what I wanted. Wider but not too wide for the trails and improved handling. Whether it's true or not I didn't want to pass up getting a new pair for $40. I can measure then once I get mine back and show you the difference though if you'd like.
Posted: Tue Aug 05, 2003 8:01 pm
by MXMIKE
Here is what I found buy comparing the two.
The dale hub is 2 inches long there is also a 1/2 inch beveled spacer that goes on before the hub.In total 2 and 1/2 inches long.
The 400ex hub is 3 and 1/4 inches long
I think the problem will be the ex hub will fit but not enough thread to put the koter key in to hold the nut.
But I think if you run the ex hub with out the 1/2 inch stock spacer it will work because the ex hubs are offset about 1/2 inch.
I will try and put my ex hubs on my rpm axel this week and let yall kow how it goes.If it works I will post some pics.