My swing arm had some slop in it so I decided to rebuild it, thats were the problems started. The right side (sprocket side) bearings practically fell out, the left side bearings I had to drive out with a bearing driver. When I tried to reassemble there is nowhere for the roller bearing to ride on the right hand side it looks like I'm missing a sleeve. Any ideas guys?
Looks like I'm missing a sleeve.
[attachment=11900:cannonda...wing_arm.jpg]
left side with a sleeve.
[attachment=11898:cannonda...ing_arm2.jpg]
Looks like my pics got switched
Swing arm question
You're right, there's a sleeve that must've came out on the outer race. I would've said you were lucky to have that updated swinger with the sleeve, but given you don't have the sleeve anymore, ehh maybe not so lucky! The sleeve was a great improvement that covered a hole in mounting tube. That hole makes for a large area where the outer race isn't supported and premature bearing failure results.
I'd imagine if you scour the vendors, you'll find a replacement.
I'd imagine if you scour the vendors, you'll find a replacement.