The bearings that sit in the middle of the swingarm where the pivot bolt goes through how do I remove them so I can powder coat?? Also who make new bearings for them an also carrier bearings?? Thanks guys
check out the site sponcers, you can get almost anything from them and at a good price also. Boomer has a kit for the pivot which has grease fittings and everything you need to install them includeing pics, tech support also if needed
It's been a wile but I'm sure they can come out either way/side? I think once you remove the inner seal "motor side" Find a socket that fits it and go for it.
It's been a wile but I'm sure they can come out either way/side? I think once you remove the inner seal "motor side" Find a socket that fits it and go for it.