Page 1 of 1
Posted: Mon Mar 12, 2012 4:01 am
by cannondale719
The bearings that sit in the middle of the swingarm where the pivot bolt goes through how do I remove them so I can powder coat?? Also who make new bearings for them an also carrier bearings?? Thanks guys
Posted: Tue Mar 13, 2012 1:23 pm
by MX Quad Dad
check out the site sponcers, you can get almost anything from them and at a good price also. Boomer has a kit for the pivot which has grease fittings and everything you need to install them includeing pics, tech support also if needed
Posted: Tue Mar 13, 2012 7:07 pm
by claas900
A few sockets and a vice, or a hammer and a socket. I like to use a vice. Or a press works also.
Posted: Thu Mar 15, 2012 4:44 am
by cannondale719
Ok can I get them out both one way or are they separate ways they come out?
A few sockets and a vice, or a hammer and a socket. I like to use a vice. Or a press works also.
Posted: Thu Mar 15, 2012 5:43 am
by claas900
It's been a wile but I'm sure they can come out either way/side? I think once you remove the inner seal "motor side" Find a socket that fits it and go for it.
Posted: Fri Mar 16, 2012 5:27 am
by cannondale719
Ok sounds good thanks guys for the help and fast responses!!
It's been a wile but I'm sure they can come out either way/side? I think once you remove the inner seal "motor side" Find a socket that fits it and go for it.