Spindle taper (ball joint)

Message

Kuma · #1 Post by **Kuma** » Tue Jun 09, 2015 11:21 pm

Does anyone know what the taper is for the ball joints on the 'dale spindles? I am doing a little project and checking into my options, what ball joints or rod ends are available to use without using a sleeve?

kdeal · #2 Post by **kdeal** » Wed Jun 10, 2015 1:29 am

I believe the Kawasaki KFX spindle taper is the same.

Kuma · #3 Post by **Kuma** » Thu Jun 11, 2015 12:30 am

QUOTE (kdeal @ Jun 9 2015, 06:29 PM) <{POST_SNAPBACK}>

I believe the Kawasaki KFX spindle taper is the same.

No other information out there? anything automotive work, VW, chevy, ford, mopar something?

Canniboomer · #4 Post by **Canniboomer** » Thu Jun 11, 2015 7:13 pm

Moog and other balljoints for an MG Metro?.. but I don't have ready access to that stash of R&D stock right now, so I cannot confirm.

SlOoT · #5 Post by **SlOoT** » Sat Jun 13, 2015 6:24 am

Rover 100 Serie, Metro. From "All Brake Systems" partnr: 220249.

I used those ball joints in stock and Moto a-arms.

Kuma · #6 Post by **Kuma** » Mon Jun 22, 2015 4:31 am

QUOTE (SlOoT @ Jun 12 2015, 11:24 PM) <{POST_SNAPBACK}>

Rover 100 Serie, Metro. From "All Brake Systems" partnr: 220249.

I used those ball joints in stock and Moto a-arms.

FYI
Found something that should work and should be more common here on this side of the pond.
Ball joint K9802, it is for '92-'01 Acura Integra and Honda Civic CRV