Stock A-arm with Heims

Message

JJNelson · #1 Post by **JJNelson** » Sat Jul 08, 2017 8:51 pm

So I modded my stock arms. I drilled to 13/16", tapped them 7/8-14, cut off old ball joint socket, and used a small air grinder to get a clean finish. I bought the parts from ASR.

who_gives_a6 · #2 Post by **who_gives_a6** » Mon Jul 10, 2017 10:30 am

Looks nice but be warned of the ASR heims. I've used quite a few of them and they simply don't last. Best to source from somewhere else on your next replacement. I've had the rubber seals pop within an hour of riding before and slop within a few more. They usually replace a set if they fail but it just keeps happening and it gets frustrating.