Page 1 of 1
help again???
Posted: Fri Oct 10, 2003 12:30 am
by justfine
Well, I carteheeled the ol' Moto again (several times), and once again I have bent the steering stem. I have a replacement and I have the old one almost out, but I can't get the stem out of the bearing at the frame. I have tried to knock it out with a hammer. I have pulled on it until I became blue in the face, and it will not budge. Any help would be much appriceated. Thanks.:confused:
jeezzz folks.........
Posted: Fri Oct 10, 2003 11:27 pm
by justfine
Not everyone at once. Come on. Help me out here. I am having a heck of a time getting that part at the bottom of the stem out that goes into the bearing. Any help??????
Posted: Fri Oct 10, 2003 11:40 pm
by thomez
Sorry I really don't know but I can help keep it up towards the top til someone does. How's that sound?
Have you tried something like Liquid Wrench to maybe help out?
This is aggggggrreeevatinggggg!!!!!!
Posted: Sat Oct 11, 2003 1:09 am
by justfine
I put the bars back on it, and I had someone pull up on the bars, and I tried to hammer it out from the bottom. This thing just won't budge. As I said before any help will do.
well.....
Posted: Sun Oct 12, 2003 2:54 am
by justfine
Thanks for all the help guys.........just playin. I had to use an air hammer to get it out. That thing was in there way too tight. Have I offended some people on here? I just ask because nobody answers most of my posts. Actually not too many people answer many posts on here.
Posted: Sun Oct 12, 2003 12:41 pm
by Big Winky
just,
sorry about responses, I usually will answer things like this but have been very busy in the shop...so not much time left for puter. I have noticed that the plating on the bottom of the stem will corrode in the bearing. The easiest way to remove is:
unbolt the steering stem bearing retainer and pull the whole assembly up and out, then use a bearing puller to remove the bearing. The top and bottom of the stock retainer will be out of the way (it's sandwiches the bearing). If you destroyed the retainer in removing the stem.... check out our billet steering stem bearing retainer.
Posted: Mon Oct 13, 2003 7:50 pm
by Mjollnir
Shooot, I've been offline for the last week, or I would have given you my response.
I've never done the steering stem removal operation before, but if the part is no longer good for use as anything except a bonking stick or breaker-bar-leverage-maker, I've never met a stuck part that I couldn't convince to see things my way through the liberal application of a Sawzall and a BFH.
