Cannondaleriders

Posted: **Mon Nov 24, 2003 5:44 pm**

Do You guys know If the swing arm bearings out of another quad or bike are the same as the cannondales?

And are the clutch friction plates the same as another bike or quad?

I know I can get these from a cannondale dealer or ATK or cdaleparts.com but I have a sponsorship thru a company that sell a lot of parts for other bikes and quads but they dont list the parts for cannondales yet and I thought if someone knew then I could order my parts from them.

Thanks

Posted: **Mon Nov 24, 2003 7:19 pm**

I think i heard that 400EX bearings will work in the axle carrier for the dales.

Posted: **Mon Nov 24, 2003 8:54 pm**

Yea 400ex axle bearings are the same but I am looking for the swing arm pivot bearings

Posted: **Mon Nov 24, 2003 8:58 pm**

There's a great list of parts and suppliers here

Posted: **Mon Nov 24, 2003 10:36 pm**

Big Winky has got your setup and its sweet! I think the complete kit is $125. Factory swing arm pivot bearings are close to $70. PM Big Winky or Haydug for set of those bearings.

Posted: **Tue Nov 25, 2003 2:59 pm**

Yep, Wink makes an awesome setup. I have a couple in stock, or I'm sure Jim has some to.

Posted: **Tue Nov 25, 2003 3:26 pm**

If I have to I will get them from you but it would be nice to know if I could use my sponsorship and get them cheaper if they match another bike.

Thanks

Posted: **Thu Nov 27, 2003 1:16 pm**

the c-dale uses an set-up like no other.

Cannondaleriders

Swing arm Bearings

Swing arm Bearings

moto50