Page 1 of 1
Setup question
Posted: Wed Mar 03, 2004 3:57 pm
by TheJaspMan
If I go with +3 A-Arms and a 4-1 off set on the front wheels. And then use a 2+2 axle what off set rear wheels am I going to need to match the front?
TIA
Posted: Wed Mar 03, 2004 9:17 pm
by jfarrar
if it is an 8'' wheel use 3in 5 out offset depending on what tirer you use that will put you like 49 inches wide close to the front depending on where your ride height is set at
Posted: Wed Mar 03, 2004 9:21 pm
by TheJaspMan
QUOTE
Originally posted by jfarrar
if it is an 8'' wheel use 3in 5 out offset depending on what tirer you use that will put you like 49 inches wide close to the front depending on where your ride height is set at
With a good suspension is there any reason to go down to an 8" rim? I was kinda looking at staying with the 9" and run 18x10x9 Holeshots for MX.
Posted: Wed Mar 03, 2004 9:43 pm
by jfarrar
you will have no problem at all.alot of guys are running the 9 '' rims.less flex in the tire.personal preference.i think the 9'' wheels only come in a 3-6 offset though you will have to run one of the spacers on your axle on the outside to keep her under 50.what axle you got?you should have a 1'' spacer on each side.
Posted: Wed Mar 03, 2004 9:46 pm
by TheJaspMan
QUOTE
Originally posted by jfarrar
you will have no problem at all.alot of guys are running the 9 '' rims.less flex in the tire.personal preference.i think the 9'' wheels only come in a 3-6 offset though you will have to run one of the spacers on your axle on the outside to keep her under 50.what axle you got?you should have a 1'' spacer on each side.
LSR 2+2 Axle. The only reason I was wanting to stick with 9" is because I already have a new set of 9" Holeshots. I would rather run as close to the same length front and back though.