rear shock compression
Posted: Sat Jun 19, 2004 5:38 pm
guys
just a small quick question for ya
i was changing my header pipe/ tightnening down the header bolts, and when i finished i went to swing the rear shock back into place, and the hole in the top of the shock was not in line with the two holes in the frame so the bolt could slide through.
it seems as if its compresses about 3-5mm b/c it wont align now and i can fit the bolt back into place?
how can i lenghten the shock so i can fit that top shock mount bolt back into place?
thanks!
just a small quick question for ya
i was changing my header pipe/ tightnening down the header bolts, and when i finished i went to swing the rear shock back into place, and the hole in the top of the shock was not in line with the two holes in the frame so the bolt could slide through.
it seems as if its compresses about 3-5mm b/c it wont align now and i can fit the bolt back into place?
how can i lenghten the shock so i can fit that top shock mount bolt back into place?
thanks!