Page 1 of 1
Moto axle
Posted: Thu Mar 03, 2005 6:35 pm
by MichiganMXer722
Putting a moto axle on today, how many black spacer am i supposed to have on each end? I have 3 on each end and it seem like i could go wider, just wondering what if i have the correct #
jordan
Posted: Thu Mar 03, 2005 8:04 pm
by wistech
Parts book shows 6 total. I got more if you think you could use them.
Posted: Fri Mar 04, 2005 12:57 am
by MichiganMXer722
I got it all put together and measure the rear end, i'm just under 48 inches, i think the 8 inch hipers with the intergrated hub has a messed up offset. If you have a couple of those spacer's i'd take 2. PM your paypal address and i'll send you whatever you need.
2nd problem: went to put on my motor mount update kit, my AC nerfs mount to the engine mounts and the bolt isn't long enough to go all the way through, any ideas?
Thanx again jordan
Posted: Fri Mar 04, 2005 1:46 am
by wistech
What length bolt do you need? Give me the size and length and i should be able to make you one.
Posted: Fri Mar 04, 2005 2:10 am
by MichiganMXer722
Alright, i'll have to get back to you on that, i know the one i have is about 1 and a half to short, i'll measure it tomorow and snap a pic of it.
jordan