Page 1 of 1
400ex rear hubs
Posted: Thu Mar 31, 2005 8:47 pm
by guthrie08
i have a new rpm axle and have been reading i need 400ex hubs to get it 50 inches. is there a certain model/year or will any stock 400ex hubs work. will these hubs slide right on my rpm axle or will i have to pound them on.
Posted: Thu Mar 31, 2005 8:51 pm
by Psychosis
Mine reaches a little over 50" w/the stock hubs. I'm not sure on the longer axles but the shorter stock ones are a pain to put EX ones on. I believe Honda changed the hubs for the 04 models and like doubled the price. But I believe they're all the same in general. I use 03 ones on one of mine and other than some banging to get them on, they worked alright.
Posted: Thu Mar 31, 2005 8:59 pm
by guthrie08
your running stock cannondale hubs with your aftermarket axle and it was a little above 50 inches?
Posted: Thu Mar 31, 2005 9:48 pm
by cdalemx301
I am about 51" in the rear with stock cannondale hubs and a LSR axle
Posted: Thu Mar 31, 2005 10:11 pm
by dawzie
It also depends on which offset rims you have and what tires. Mine measures 49" wide with zero offset rims.
Posted: Thu Mar 31, 2005 11:01 pm
by guthrie08
i was going to run a 8*8, 3+6 offset with a rpm axle and stock hubs, what width do guys think ill be around.