Today I got my hotwire coil put on. (to refresh your memory, I re-built the bike with a timbo stroker and could not get it to run, I decided I had a short so I replaced the coil with a hotwire system. Ive already had the motor off once to check timing) It sparks nice and bright on the head. I took my throtle body off again and Im still spraying fuel. I put it all together and tried it. NOTHING. I took the throtle body off and turned it over and I got poping from the exaust and a large flame or two. I put it back together, nothing but the sound of cranking it over.
Are the pops and flames a good sign? Do I need to adjust my idle/fuel settings?
still not running
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
Did you change ECU to a stroker-optimized map? If not, you might want to send the ECU off to a stroker-map guru, or yes try turning up the idle screw for start-sake.
The hotwire coil itself will always start-up a previously "running" motor, and maybe need some minor extra fuel, but not a huge amount of adjustment. You still have same problem as before, just with a better spark. Is it a new tight piston also?, maybe not getting enough fuel your new motor?, or not quite enough battery oomph?.. somebody will post here in morning, see ya!
The hotwire coil itself will always start-up a previously "running" motor, and maybe need some minor extra fuel, but not a huge amount of adjustment. You still have same problem as before, just with a better spark. Is it a new tight piston also?, maybe not getting enough fuel your new motor?, or not quite enough battery oomph?.. somebody will post here in morning, see ya!
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm