Sprocket hub

Message

skinny · #1 Post by **skinny** » Thu Oct 20, 2005 2:29 pm

I have a stock axle and sprocket hub but for some reason the splines in the hub just stripped. I was wondering if there is a better aftermarket replacement, can I use one from another quad? Just trying to figure out what my options are? Thanks

wistech · #2 Post by **wistech** » Thu Oct 20, 2005 4:38 pm

Id say the stockers are the best. I use green locktite on them to make sure they hold and havent had trouble in 2 years.

TheJaspMan · #3 Post by **TheJaspMan** » Thu Oct 20, 2005 7:30 pm

I would never get rid of the stock one. I even pressed one onto my LSR axle.

skinny · #4 Post by **skinny** » Fri Oct 21, 2005 8:14 pm

I guess nobody else has ever had this problem? I didn't know if I was only one or if some else had this is issue before. Sounds like I'm just gonna buy a stock replacement and hope that it doesn't happen again. Thanks

cdaleracer · #5 Post by **cdaleracer** » Sun Oct 23, 2005 5:08 pm

I've had it happen with two LSR sprocket hubs. But never a stocke one.