Hose/wire placement?

Message

jshort · #1 Post by **jshort** » Wed Nov 02, 2005 7:27 am

I just installed my motor back in my quad and now the fun begins. I am worried I am not going to be able to get all the hoses placed correctly. Does anyone have tips or pictures that can help?

Thanks,
Jason

cannondale27 · #2 Post by **cannondale27** » Wed Nov 02, 2005 12:37 pm

Other than radiator hoses all you have is the vacuum hoses.find the T or Cross.One end goes to regulator,one too the ECU and one too the airbox.If you have a cross (four way connector)then tranny vent (on top middle of big sidecover) goes to fourth one.Otherwise it just hangs down below fuel pump.Fuel line(which need to be checked for cracks)Return line(on right side of tank)goes from tank to regulator from regulator line goes up to right side injector.Line between injectors then another line to top fitting of fuel pump and finally a line from bottom of pump to filter then to tank left fitting (if late tank)or to back fitting if this is case run the line alongside the motor not over it.