Whats some things I can check & do to make my motor as reliable as possible?
So far I want to do:
Stage 8 Kit
Motor Mount Update
Gapless Piston Ring
Check for Updated Water Impeller
I'm I missing anything?
Thanks
Making these motors as bullet proof as possible?
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
How about some parts ???? I"m stuck with the transmission filter access bolt as usual not enough antisieze and it trashed the head trying to pull it off . along with a stage a update kit , anybody know where i can locate one ..... my stealer is an A$$ all cocky about the chapter 11 stuff and rubbing it in is destroying their reputation as i have spoken to a dozen or so friends and once word of mouth is rolling well needless to say we have been shopping elsewhere .
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
CDale 27 has the Stage 8 stud update kit. I have heard some guys just pulling out the allenhead screws and using red or green loctite on them and have had no problems. As for your tranny bolt I would call the quad shop or R & S for one. There was a thread on that issue recently I just don't know when.
hmmm
I have some questions?
Do you think a SSM case with the Crankcase Update and Mount Update would be as reliable as a Non-SSM Case with those Updates?
Also my motor is about ready for a "reliability" overhaul this is whats I'm planning on doing.
Stage 8 Crankcase Update Kit
New all plastic Impeller (Dealer is doing that if thats my problem)
Check Valve Cover and try to find an Aluminum Replacement
Check Cylinder sleeve. (Dont know about its problems, but I've heard of some so if anyone can explain, I would appreciate it)
Gapless Ring
FDO Port Job
Motor Mount Update
Check Valve Seats (Same as Cylinder Sleeve)
Check for Plastic Oil Pump gears
Battery Tray Update
Did I miss anything? Any suggestions or tips?
Thanks alot
Do you think a SSM case with the Crankcase Update and Mount Update would be as reliable as a Non-SSM Case with those Updates?
Also my motor is about ready for a "reliability" overhaul this is whats I'm planning on doing.
Stage 8 Crankcase Update Kit
New all plastic Impeller (Dealer is doing that if thats my problem)
Check Valve Cover and try to find an Aluminum Replacement
Check Cylinder sleeve. (Dont know about its problems, but I've heard of some so if anyone can explain, I would appreciate it)
Gapless Ring
FDO Port Job
Motor Mount Update
Check Valve Seats (Same as Cylinder Sleeve)
Check for Plastic Oil Pump gears
Battery Tray Update
Did I miss anything? Any suggestions or tips?
Thanks alot