Hey everyone,
I just bought a new motor for 02 moto and I'm going to sell mine. It had a rebuild done by ATK about 10 hours ago and runs strong. The only problem with it is that oil check ball valve is sticking now. I have been told it should fix itself but I haven't rode it enough latley to fix it. It is the Hydo clutch and I have all the receipts from ATK on the work done. Here is a list of what they did.
Rebuild Cannondale Engine: includes complete gasket set with seals, crank in good condition, and new piston and rings. -$1100
New Raw Engine Casings -$401.78
Engine Rail Weldment - $148.20
Bearing, 25x62x17mm, Plstc -$42.14
Ball Bearing - $8.99
Clutch Plate, Fri*DNB*, 22.32mm - $12.28
Cam Cover Assy - $157.86
Any help on what I can get for this would be great.
Thanks,
Eric
How much could I sell this motor for
Engine, intake, exhaust, EFI, chain, sprockets, etc.
Message
Author
Jump to
- Vendors
- ↳ Matczak Machining (aka: timbomoose)
- ↳ Blackwidow ATV
- ↳ Canno Moto
- ↳ THE SHOCK DOC
- ↳ Announcements and Specials
- ↳ Vendor Polls
- ↳ Archive
- ↳ MX-Tech suspension (East Coast)
- ↳ Teixeira Tech
- ↳ Hiper Technology
- ↳ R.I.S. DESIGNS
- ↳ P.C. PRODUCTS
- ↳ Great Lakes Quad Racing Action
- ↳ Joe and Mike Creations
- Riders
- ↳ CannondaleRiders Race Reports
- ↳ Where to Ride
- ↳ Trail Tales
- ↳ Dune Tales
- ↳ Mini Forum
- ↳ Events/Races
- Mechanical
- ↳ Steering and Suspension
- ↳ Powertrain
- ↳ Body
- ↳ Maintenance
- ↳ Dyno Charts
- ↳ Cannondale Motorcycles
- ↳ Cannondale Quads
- ↳ Mapping
- ↳ R&D
- ↳ Updates and tips
- General
- ↳ Open Forum
- ↳ Frequently Asked Questions
- ↳ Non-Cannondale Forum
- ↳ Faqs and How To Articles
- ↳ Trivia
- Classifieds
- ↳ For Sale
- ↳ Wanted
- ↳ Trader Feedback
- Miscellaneous
- ↳ Comments and Suggestions
- ↳ Cannondaleriders Quad/Bike/Rider of the Month
- ↳ CANNONDALERIDERS STORE
- ↳ TEAM CANNONDALERIDERS