anyone seen this before?
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
The weight itself is pretty tight, I don't think the motor's done much, looking at the rest of it (not that it seems to matter!) The cams and followers are pretty mint.....
It looks like there has been a bit of core shift on the casting and the sides of the tappet-bore are higher up than usual.... If you look you can see very little of the bucket above the sides of the bore. Clearances are good and they have a 245 shim which is similar to the others I've had to bits....
My other heads are all at the flowbench guys place so I have none here to compare this one with....
Another interesting glitch to look out for....
It looks like there has been a bit of core shift on the casting and the sides of the tappet-bore are higher up than usual.... If you look you can see very little of the bucket above the sides of the bore. Clearances are good and they have a 245 shim which is similar to the others I've had to bits....
My other heads are all at the flowbench guys place so I have none here to compare this one with....
Another interesting glitch to look out for....
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm