Crankcase Vent Update ??
Crankcase Vent Update ??
I have a 03 Cannibal and I want to do the crankcase vent update to it. Can anyone give me some play by play and some insight about where I can get the need materials? I was told that ????????????????T??????????????????ing the line that runs from the started clutch cover to the spar with the line that runs from a ????????????????T??????????????? under the air box together (and connected to the banjo fitting / oil drain) will fix the problem???????????????.but I am a bit skeptical as the factory call for a bit more, including the use of larger hoses. Some guidance and help on locating the parts need would be great!
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
I would look into a possible deeper issue. When you are getting oil in the air box this usually means your crank plate gasket is not sealing good enough.
I have seen this on multiple occasions. There is a small seal that seperates the crank from the outer case area. If this seal starts to leak it will pressureise the case and blow oil out the breather.
In addition this could mean your crank plate bolts are backing out. If this happens it could mean cretain death for your engine. I would check it out if you have not had an update done to your engine already.
I have seen this on multiple occasions. There is a small seal that seperates the crank from the outer case area. If this seal starts to leak it will pressureise the case and blow oil out the breather.
In addition this could mean your crank plate bolts are backing out. If this happens it could mean cretain death for your engine. I would check it out if you have not had an update done to your engine already.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm