just cranks
Just got my Blaze put back together went to start just cranks. I checked all connections everything is where it should be, got spark, fuel pump is running while motor is cranking but I don't think the injectors are squirting is that possible. It was just a crank replacement so all I needed to do was set it at top dead center put the cams in the up location like it shows in the book put timing chain on and be good correct. So if anyone can help that would be good.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
QUOTE (thedeatons @ Aug 16 2008, 08:28 PM) <{POST_SNAPBACK}>
Do a compression test if all those other suggestions check out good. You should have 90-100psi.
found the prob fuel pump running just not pumping
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
QUOTE (Denny @ Aug 20 2008, 02:31 PM) <{POST_SNAPBACK}>
found the prob fuel pump running just not pumping
How did you figure that out? Did you have to buy a new one? I'm having the same problem. My fuel filter has bubbles in it when cranking then drains mostly empty when not being cranked. Any advice? I have spark and good gas and battery but it just won't fire? I'm wondering if I have an air leak in the fuel lines but there's good fuel flow in the gas tank when cranking. The pump definitely primes but my plug doesn't get very wet and it doesn't really fire at all... My only thoughts are maybe the injectors from sitting if it's not the fuel lines...
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm