starts and Dies??
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
My 440s starts and Dies, when it finally stays running it reves to 4500 rpm, then whin i try to idle it down the bottom falls out and it dies.
I R&R stepper and put in new Injectors, fuel flow seems strong as filter is constianty flowing fuel thru it.
any thoughts??
electrical, restricted fuleline, failing pump or pressure regulator??
Higher # on injector offset means richer at Idle correct? currently .85
leakage is set @ 0
Thanks Kurt
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
Did you happen to load a map without going into the update calibrations and switching them over to what you got from reading the previous calibrations instead of what automatically comes from the map? Sometimes the flow rate that automatically populates from the new map is a dangerously low and lean flow rate of 2600 for most motors.
Tell us what your flow rate number is reading the cal's and also what your tps percentage is when it is running and that would tell us more but that .85 offset is among the leanest I have seen and right off the bat I would maybe try .95 or 1.0 to see if it helps. Also if the motor and exhaust is stock or not would help us dial you in more. Also make darn sure that you are doing the throttle cal correctly by backing off everything to get the closed reading... I know that is a pain.
Tell us what your flow rate number is reading the cal's and also what your tps percentage is when it is running and that would tell us more but that .85 offset is among the leanest I have seen and right off the bat I would maybe try .95 or 1.0 to see if it helps. Also if the motor and exhaust is stock or not would help us dial you in more. Also make darn sure that you are doing the throttle cal correctly by backing off everything to get the closed reading... I know that is a pain.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm