Don't like the thumb throttle's design...
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
It is REALLY super simple to do......
1) first (obviously) unhook the C'dale t-thottle and pitch it into a box on the shelf
2) grab your spare 400ex t-throttle
3) put it on the bars to hold it in place while you work on it
4) get a drill out with an assortment of bits
5) here's where the going gets tough.....you need to drill JUST A LITTLE BIT out of where an ex theads into the body. In reality, a file could probably do it also. Drill where an ex throttle threads in just enough so that the C'dale cable will slide in there far enough to be able to hook up the cable.
-side note- leave that little rubber piece ON the throttle cable that is used as a seal on the Dale throttle assembly, this now acts as your "overtravel spring" What happens is that the ex has a slightly longer throw than the dale, instead of creating a stop, you let the cable fully open the trottle housing, and the rubber will compress the little bit more until you hit the stop so that nothing is ruined or hurt.
I have been running it like this all year and have no problems so far.
If something doesn't make sense, just let me know and I'll try to explain better or get a couple of pic's.
1) first (obviously) unhook the C'dale t-thottle and pitch it into a box on the shelf
2) grab your spare 400ex t-throttle
3) put it on the bars to hold it in place while you work on it
4) get a drill out with an assortment of bits
5) here's where the going gets tough.....you need to drill JUST A LITTLE BIT out of where an ex theads into the body. In reality, a file could probably do it also. Drill where an ex throttle threads in just enough so that the C'dale cable will slide in there far enough to be able to hook up the cable.
-side note- leave that little rubber piece ON the throttle cable that is used as a seal on the Dale throttle assembly, this now acts as your "overtravel spring" What happens is that the ex has a slightly longer throw than the dale, instead of creating a stop, you let the cable fully open the trottle housing, and the rubber will compress the little bit more until you hit the stop so that nothing is ruined or hurt.
I have been running it like this all year and have no problems so far.
If something doesn't make sense, just let me know and I'll try to explain better or get a couple of pic's.
yes, it opens all the way. You actually have the throttle body open all the way before the thumb-trottle hits the stops. That is where leaving the rubber piece on comes into play, it allows you to push the thumb right to the stops without stretching the cable. Basically, when the thottle body is wide open and you push your thumb a little farther to the stops, it compresses the rubber a little bit.