Ive got the quietest Dale ever.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
Clarification
My buddy is the service manager at our local ford dealership. I ran all this by him so he could hook me up witht he stuff I need.
wistech, can you confirm for me? Here's what the guy replied back;
The 1830856C1 looks like an International Harvester part#. Ford recently changed all its silicone part numbers and marketed them under Motorcraft instead of Ford.
I belive the silicone you are looking for is a Motorcraft #TA-31 made espically for the 7.3L diesel engine. Check with your guy to see if that part # is the same. The instructions say to use a part# ZC-31 metal surface cleaner before applying, I would reccomend that because it is not being held in by anything.
Let me know
.
wistech, can you confirm for me? Here's what the guy replied back;
The 1830856C1 looks like an International Harvester part#. Ford recently changed all its silicone part numbers and marketed them under Motorcraft instead of Ford.
I belive the silicone you are looking for is a Motorcraft #TA-31 made espically for the 7.3L diesel engine. Check with your guy to see if that part # is the same. The instructions say to use a part# ZC-31 metal surface cleaner before applying, I would reccomend that because it is not being held in by anything.
Let me know
.
Yep that sounds like the stuff. There are other other silicones out there that would be just as good. I know that the high heat orange permatex 26BR is is pretty tenatious at sticking to parts.
Just like getting automotive paint to adhere you need clean oil free parts. I find it strange that some of you are so worried about it actually coming off the covers. You should see what it takes to get this stuff off an diesel oil pan. A razor blade and roloc bristle disc will grind it off but it fights every inch of the way.
Just like getting automotive paint to adhere you need clean oil free parts. I find it strange that some of you are so worried about it actually coming off the covers. You should see what it takes to get this stuff off an diesel oil pan. A razor blade and roloc bristle disc will grind it off but it fights every inch of the way.
Good thing Blaze said something about the vent hole. I got to thinking about it last night so today I dropped my motor again and sure enough, it was filled. I remember going around it but when I was doing the clutch cover I asked my friend to smooth out some of the big cover. He must have just rubbed it right in. I just went ahead and pressure washed it all off. I'll probably try it again after I hear some more good results.
Tool dip (not that tool)
Hey what about using the spray on tool dip from plastidip.com they sell it everywhere comes in differen't colors so if you did the exterior of the side cover it may not look bad it is a satin finish, I may have to try it since I ain't yankin my engine during riding season in Norcal. Oh it does have safety warnings about not using as a condom, but does resist chemicals acids , oils and heat.
Dave
Dave
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm