Starting Prob.

Message

housercdale · #11 Post by **housercdale** » Tue May 10, 2005 5:05 am

Motor worked before, but in another quad. I got a roller and put it in the roller. Don't know what was wrong with the roller. I'll be checking hose and connections tomarrow.

housercdale · #12 Post by **housercdale** » Wed May 11, 2005 10:09 pm

Still no luck any ideas? What kind of presure should the fuel pump be putting out?

jwheat · #13 Post by **jwheat** » Wed May 11, 2005 10:17 pm

40-45 PSI

housercdale · #14 Post by **housercdale** » Wed May 11, 2005 11:25 pm

Have the presure, even change the fuel pump. Don't know what else to try. All the connections even lok good. It will start sometimes. When it does it seems to run good. But it will only start maybe 1 out of 100 times. No clue.....

bombsquad54 · #15 Post by **bombsquad54** » Wed May 11, 2005 11:48 pm

check your fuel injector sensor connections, could be loose or something broke in the connection

housercdale · #16 Post by **housercdale** » Wed May 11, 2005 11:52 pm

I'll pull them off and reconnect them just to be sure.

housercdale · #17 Post by **housercdale** » Tue May 17, 2005 8:00 pm

I can get it started almost every time, but I have to father the throutle back and fourth. I have reset the offsets numerous times with no change. Any ideas?

cannondale27 · #18 Post by **cannondale27** » Tue May 17, 2005 8:13 pm

Rubber throttle boots on right?When hooked up to D&M in continuous mode is the reading from TPS linear (smoothly goes up as throttle is given)?Check those disconnects for good flow.How far in or out is your Idle screw?Is it hard to get a low idle?

housercdale · #19 Post by **housercdale** » Tue May 17, 2005 10:26 pm

What rubber boots are your refurring too?

cannondale27 · #20 Post by **cannondale27** » Tue May 17, 2005 10:28 pm

The ones that connect the throttlebody to the intake and airbox.