Page 2 of 3
Posted: Tue May 10, 2005 5:05 am
by housercdale
Motor worked before, but in another quad. I got a roller and put it in the roller. Don't know what was wrong with the roller. I'll be checking hose and connections tomarrow.
Posted: Wed May 11, 2005 10:09 pm
by housercdale
Still no luck any ideas? What kind of presure should the fuel pump be putting out?
Posted: Wed May 11, 2005 10:17 pm
by jwheat
40-45 PSI
Posted: Wed May 11, 2005 11:25 pm
by housercdale
Have the presure, even change the fuel pump. Don't know what else to try. All the connections even lok good. It will start sometimes. When it does it seems to run good. But it will only start maybe 1 out of 100 times. No clue.....
Posted: Wed May 11, 2005 11:48 pm
by bombsquad54
check your fuel injector sensor connections, could be loose or something broke in the connection
Posted: Wed May 11, 2005 11:52 pm
by housercdale
I'll pull them off and reconnect them just to be sure.
Posted: Tue May 17, 2005 8:00 pm
by housercdale
I can get it started almost every time, but I have to father the throutle back and fourth. I have reset the offsets numerous times with no change. Any ideas?
Posted: Tue May 17, 2005 8:13 pm
by cannondale27
Rubber throttle boots on right?When hooked up to D&M in continuous mode is the reading from TPS linear (smoothly goes up as throttle is given)?Check those disconnects for good flow.How far in or out is your Idle screw?Is it hard to get a low idle?
Posted: Tue May 17, 2005 10:26 pm
by housercdale
What rubber boots are your refurring too?
Posted: Tue May 17, 2005 10:28 pm
by cannondale27
The ones that connect the throttlebody to the intake and airbox.