Page 2 of 2
Posted: Tue Apr 18, 2006 4:28 am
by Happyboy
I 4got to mention..
this is a Unicorn...Falicon,JE(high comp.),ported HDC engine....
has maybe 13hrs on it.
Sorry, I had already been drinking at this point.
Posted: Tue Apr 18, 2006 12:24 pm
by Pro400EXC
pins put in?
Posted: Wed Apr 19, 2006 5:06 am
by azcannon
If you take a new flywheel and put pins in it , it is much less likely to spin. Problem is the hub heats up when a crank main bearing ( flywheel side ) or a lower rod bearing goes out and the hub expands loosening inside of flywheel cast and then later when fresh snappy power is applied it will spin on center hub.
I have been pinning all mine and my friends( actually having ( Timbo do the work ) and have never spun one but at least 2 locals I know have.